Enrichment Coordinator Service
There are two ways to configure logging.
- Updating the application.yaml file, which requires a POD restart.
- By invoking a REST API. The changes takes effect immediately, but the changes will not survive a POD restart.
The contents of the log can be read by command:
| Code Block | ||
|---|---|---|
| ||
kubectl logs enrichmentservice-0 --namespace nonrtric |
Updating of the configuration file application.yaml
Debug logging can be enabled configured by a file; application.yaml. This file can in turn be updated by means of a config map named enrichmentservice-configmap.
The contents of the config map can be retrieved by command:>kubectl describe configmap
| Code Block | ||
|---|---|---|
| ||
kubectl describe configmap enrichmentservice-configmap -n nonrtric |
The following lines controls the logging levels (example of the default settings):
| Code Block | ||
|---|---|---|
| ||
logging: |
...
level: |
...
ROOT: |
...
ERROR org.springframework: |
...
ERROR org.springframework.data: |
...
ERROR org.springframework.web.reactive.function.client.ExchangeFunctions: |
...
ERROR org.oransc.enrichment: INFO |
If this file is put in a directory named config; ./config/application.yaml, the config map can be updated by command: >kubectl create configmap enrichmentservice
| Code Block | ||
|---|---|---|
| ||
kubectl create configmap enrichmentservice-configmap --from-file=./config --dry-run=client -n nonrtric -o yaml | kubectl apply -f - |
A POD restart is required for the change to take place.
Configuring logging using the REST API
Debug logging can also be configured by using REST. This does not require a POD restart. The configuration will on the other hand revert to the default after a POD restart. Here follows an example on how to enable debug level tracing on the whole component (all classes in the org.oransc.enrichment package):
>curl http://172.17.0.7:8083/actuator/loggers/org.oransc.enrichment -i -X POST -H 'Content-Type: application/json' -d '{"configuredLevel":"debug"}'
You can get the IP address and the port of the POD by command:
| Code Block | ||
|---|---|---|
| ||
kubectl describe pod enrichmentservice-0 -n nonrtric |
Policy Management Service
There are two ways to configure logging.
- Updating the application.yaml file, which requires a POD restart.
- By invoking a REST API. The changes takes effect immediately, but the changes will not survive a POD restart.
The contents of the log can be read by command:
| Code Block | ||
|---|---|---|
| ||
kubectl logs policymanagementservice-0 --namespace nonrtric |
Updating of the configuration file application.yaml
Debug logging in the the PMS can be done in configured the same was as for the Enrichment Coordinator Service (described above). The difference is that the name of the config map is policymanagementservice-configmap-config.
Configuring logging using the REST API
In the same was for the PMS, debug logging can also be configured by using REST. This does not require a POD restart. The traces will on the other hand revert to the default after a POD restart. Here follows an example on how to enable debug level tracing on the whole component (all classes in the org.onap.ccsdk.oran.a1policymanagementservice package):
>curl http://172.17.0.6:8081/actuator/loggers/org.onap.ccsdk.oran.a1policymanagementservice -i -X POST -H 'Content-Type: application/json' -d '{"configuredLevel":"debug"}'
You can get the IP address and the port of the POD by command:
| Code Block | ||
|---|---|---|
| ||
kubectl describe pod policymanagementservice-0 -n nonrtric |